Unitech Hand Held Scanner Manual de usuario descargar pdf (Pagina 9)

Chapter 2

Keyboard Interface

As a keyboard Interface, the scanner is actually installed between a PC (or

terminal) and a keyboard. See Figure for reference. The scanner sends data to

the host device by emulating the keyboard input and acts like an extension of

the keyboard.

Installation

This scanner can be installed easily by following the installation guide

illustrated below. Before you start the installation, locate a "Y" type cable in the

package.

Installation procedures:

1) Plug the modular (RJ45) connector of the "Y" cable into the bottom of the

scanner until you hear a click sound.

Installed as a Keyboard Interface

2) Turn off your PC or terminal.

3) Unplug the keyboard from the PC or terminal.

4) Plug the keyboard into a connector of the Y cable that mates with it.

5) Plug the remaining connector of the "Y" cable into the keyboard port of

your PC or terminal.

6) Power up your PC or terminal you press the switch the beam should be

out from the scanner.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 63 64

Sin comentarios

Unitech Hand Held Scanner Manual de usuario Pagina 9