Unitech PA982 Manual de usuario descargar pdf (Pagina 27)

reset the setting area into FF. m=2 is upload

setting.

Actually you just need the format as bellow:

Download:

Esc,1,02,91,0,s1,...,s255,BCC

Upload:

Esc,0,3,91,2,BCC

EAN128Brace

Remove

Esc,0,4,92,m,S1,BCC S1 is =0_disable,1 enable(Remove the brace)

AimingTime

Esc,0,4,93,m,S1,BCC S1 is =0 0.5s,1_1s,2 1.5s 3 2s

Exchange data Esc,Lh,Ll,a3,S1,S2,....,Sn,

BCC

• Expect Acknowledge (Esc,80H+ACK(06H))

• Exchange the data between the host and the

ICC.

• Expected return after issuing

Execute/Enquiry command are:

Esc,Lh,Ll,0xa3,AH,data,BCC

Here: AH=0 Success

=1 Timeout

=2 No card present

data: Response data and status word

Note: Hamster save these commands to buffer and do not execute until it receives

an Execute command (Esc,ENQ). Hamster execute the command after receive an

“Esc,ENQ” then send back a reply. The Max. Length of data is 264. The m and the

reply define as following:

DATA TO HOST FROM HAMSTER

Data format: Code_number,Lh,Ll,string

Here: The Lh/Ll is string length, Lh is high byte, Ll is low byte, The string

length is excluded the Code_number and Lh/Ll. The string contains the Code ID,

pre_amble, scanned data,post_amble, and terminator. Code_number is equal to

following number plus H’80.

0 Code 39 full ASCII 1 Code 39 standard or EDP Code 2 EAN 13 3 UPC A

4 EAN 8 5 UPC E 6 I25 7 Codabar 8 Code 128 9 Code 93

10 S25 11 MSI 12 EAN 128 13 Code 32 14 Delta 15 Label

16 Plessey 17 Code 11 18 Toshiba 19 reserved 20 Track 1 21 Track 2

22 Track 3 23 More than 1 track 24 reserved 25 RS232 26 reserved 27 reserved

28 reserved 29 reserved 30 reserved 31 reserved 32 reserved 33 reserved

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 104 105

Sin comentarios

Unitech PA982 Manual de usuario Pagina 27